I am working on a Mazak SQT 200. The job I am running has a cycle time of about 40 seconds. The program is in EIA. The control is a Fusion 640T. The shop I work at is very much against over riding any safety switches. :nono:
My question.....is there either a M code or a parameter change that I can do so that at the end of my cycle the door will unlock automatically. Currently at the end of each cycle the door unlock button needs to be pushed. Not a big deal normally....but a pain in the butt when running thousands of parts at 40 seconds apiece.......Thoughts?.....Thank you
My question.....is there either a M code or a parameter change that I can do so that at the end of my cycle the door will unlock automatically. Currently at the end of each cycle the door unlock button needs to be pushed. Not a big deal normally....but a pain in the butt when running thousands of parts at 40 seconds apiece.......Thoughts?.....Thank you