I am making some manifolds out of 6061 that have a some round male ports that have silicone hose clamped onto them. The ports are .75" to 1" OD.
Its a really low pressure system, but the customer wants a hose barb on these ports anyways. They don't care if its a single bead like what you would see rolled onto tubing or if it looks like a standard hose barb, they just want something there.
I am trying to avoid using a woodruff, or a custom form endmill, I'd like to try and find something off the shelf. I have lots of them to make so I am trying to keep the cycle time down.
I'm open to other suggestions too.
Its a really low pressure system, but the customer wants a hose barb on these ports anyways. They don't care if its a single bead like what you would see rolled onto tubing or if it looks like a standard hose barb, they just want something there.
I am trying to avoid using a woodruff, or a custom form endmill, I'd like to try and find something off the shelf. I have lots of them to make so I am trying to keep the cycle time down.
I'm open to other suggestions too.