So have a bad servomotor, and bought a new one from a giant ebay seller that appears to have a bad encoder. Wile I wait for a response I decded to see what was involved in removing the encoder from my old one. From a post on the Siemens website in semi English:
https://www.automation.siemens.com/W...70&Language=en
it looks like take out the 5mm screw put in a 6mm one and it will jack the encoder off the end of the shaft
Anyone done this? It does not want to and I hesitate to push too hard
https://www.automation.siemens.com/W...70&Language=en
it looks like take out the 5mm screw put in a 6mm one and it will jack the encoder off the end of the shaft
Anyone done this? It does not want to and I hesitate to push too hard