I have a daewoo pan-20 flat bed lathe with Fanuc 6T control. When I do a tool change on either front OR rear turret, the turret lifts off the curvic coupling, indexes, and then just keeps on indexing. It never stops indexing until I just have to kill power to get it to stop. After Trying everything I can think of to fix it I've finally said screw it and am just going to mount an aloris tool post and do tool changes manually. I'm not the best with coding, how do I call up the tool changes without causing the control to try and index a turret that is isn't there? I figure I'll put an M00 before the tool changes, but if I try to go from T0101 to T0202 I'll have a problem with the machine trying to index a non-existent turret
↧