hello all.. I Have an older conquest 42.. Great old lathe.. have been doing more and more with it, and have been operating it without a chip conveyor.. Pain, to say the least now that there is more material to deal with..
Does anyone know what size conveyor would fit this machine or can measure theirs? Figure it just fits in the spot over the tank, there is an opening I am assuming is for it on the right side.. Is there a good used one or any tips? Also, when i can't get it with the feeds and get some stringy chips, do conveyors deal with that to a degree? Will they just get sucked up through it? thanks for any help.. obviously, have had no experience with them...
Does anyone know what size conveyor would fit this machine or can measure theirs? Figure it just fits in the spot over the tank, there is an opening I am assuming is for it on the right side.. Is there a good used one or any tips? Also, when i can't get it with the feeds and get some stringy chips, do conveyors deal with that to a degree? Will they just get sucked up through it? thanks for any help.. obviously, have had no experience with them...