After getting my Mighty MV-40 a2100 hard drive fixed I now have another question:
The company I bought the machine from listed it as a Cat-40 taper. The manual says it could either be Cat-40 or BT-40. Now for the weird part - it does NOT use pull studs, It has an old school air powered ratcheting drawbar. Anyone seen this configuration before? Do I need special tool holders or will plain old cat/bt40 work?
The company I bought the machine from listed it as a Cat-40 taper. The manual says it could either be Cat-40 or BT-40. Now for the weird part - it does NOT use pull studs, It has an old school air powered ratcheting drawbar. Anyone seen this configuration before? Do I need special tool holders or will plain old cat/bt40 work?