I have a Hyundai HiT 18S with the Siemens 840-C control.
I am using the canned cycles.
I do a tool change and call up a boring tool and give it a feed rate of .006.
Then give it a roughing profile routine and again put in .006 for the feed rate. All is well.
Then give it a finishing profile routine and put in a feed rate of .002 but, it feeds at .006.
I have tried altering the feed factor to .33 thinking that it would reduce the .006, but no dice.
Any suggestions?
Thanks and regards,
Ray
I am using the canned cycles.
I do a tool change and call up a boring tool and give it a feed rate of .006.
Then give it a roughing profile routine and again put in .006 for the feed rate. All is well.
Then give it a finishing profile routine and put in a feed rate of .002 but, it feeds at .006.
I have tried altering the feed factor to .33 thinking that it would reduce the .006, but no dice.
Any suggestions?
Thanks and regards,
Ray