apologies if I have this post in the wrong area.
I had the repair guy install a recond board (pcb425d) on the power supply.Machine originally burnt this board after a scale/reader was wired the wrong way and plugged in.
after the recond boards in.the display wont light up.Also the backup battery was dead flat,after the charge up...still nothin.Machine starts up and chases with no display.
Service guy here in Oz is lost as there is very little info he can get off Anilam.He thinks it maybe that the parameters are all lost.
if so..does anyone have a copy of the parameters or where to get them?Anilam apparently dont??
and has anyone else had a similar problem.
Cheers
Karl
I had the repair guy install a recond board (pcb425d) on the power supply.Machine originally burnt this board after a scale/reader was wired the wrong way and plugged in.
after the recond boards in.the display wont light up.Also the backup battery was dead flat,after the charge up...still nothin.Machine starts up and chases with no display.
Service guy here in Oz is lost as there is very little info he can get off Anilam.He thinks it maybe that the parameters are all lost.
if so..does anyone have a copy of the parameters or where to get them?Anilam apparently dont??
and has anyone else had a similar problem.
Cheers
Karl