Ok aluminum guys I need some help. Most of my work is tool steel
and stainless so I am lost and salesmen are not helping good.
I need to drill a .315 hole 2 inches deep in 6061 aluminum.
My issue is it needs a 32 finish anyone know of a drill that can achieve
that or am I stuck doing a secondary op? Was thinking double margin
to help burnish as it drills but I am told it might bind and break in aluminum.
This is on a production run of 800 pcs/day so time is of the essence
we are trying to save every second and every penny.
and stainless so I am lost and salesmen are not helping good.
I need to drill a .315 hole 2 inches deep in 6061 aluminum.
My issue is it needs a 32 finish anyone know of a drill that can achieve
that or am I stuck doing a secondary op? Was thinking double margin
to help burnish as it drills but I am told it might bind and break in aluminum.
This is on a production run of 800 pcs/day so time is of the essence
we are trying to save every second and every penny.