Same machine as all my other recent posts - doosan S310SMLY with 18i-TB.
Whenever the spindle is running in "ordinary lathe" mode, the C axis load meter is pegged, even though the spindle load meter might be just flickering on the lowest bar. I mean on the Operating Monitor screen - there is no physical load meter for the C axis.
There doesn't seem to be any adverse effects so far, but it's a bit worrisome - the sub spindle does not display the same behaviour, A axis load meter is 0% when the sub is running.
Anyone have any clues about this?
Whenever the spindle is running in "ordinary lathe" mode, the C axis load meter is pegged, even though the spindle load meter might be just flickering on the lowest bar. I mean on the Operating Monitor screen - there is no physical load meter for the C axis.
There doesn't seem to be any adverse effects so far, but it's a bit worrisome - the sub spindle does not display the same behaviour, A axis load meter is 0% when the sub is running.
Anyone have any clues about this?