I have an Anilam Crusader M control on a Supermax knee mill (3 axis) that recently quit working. The servo drives will not come on, and the screen is blank. The screen actually turns on, but all I see is a short horizontal line blinking in the upper left corner.
On the orange tabbed card in the main rack, LED numbers 1, 4, 5 and 6 are on (not blinking).
I haven't had much time to start troubleshooting the control just yet. I'll start in the morning by checking fuses and the voltage from the power supplies.
Any input or suggestions from folks familiar with this control would be greatly appreciated.
Thanks
btm
On the orange tabbed card in the main rack, LED numbers 1, 4, 5 and 6 are on (not blinking).
I haven't had much time to start troubleshooting the control just yet. I'll start in the morning by checking fuses and the voltage from the power supplies.
Any input or suggestions from folks familiar with this control would be greatly appreciated.
Thanks
btm