I'm trying to receive a program from a FANUC Oi control. I only get a page full of F,6, and + plus characters....
The PC is running Windows 7 and I am using a RS232 connector from the CNC into a A_B type switch box that connects to the PC with a 9 pin connector. No USB connector is being used. This is not a new set up, just a new problem.
Any Solution Suggestions would be appreciated!
The PC is running Windows 7 and I am using a RS232 connector from the CNC into a A_B type switch box that connects to the PC with a 9 pin connector. No USB connector is being used. This is not a new set up, just a new problem.
Any Solution Suggestions would be appreciated!