Hello,
I recently bought this 2002 CL2000BT and am on my second job on it. I successfully ran the first job with conversational programming. So I program the second, a threaded fitting and didn't see the crash coming.
The problem is that I drilled a 1 inch hole then went to my 3/4" solid carbide boring bar, CCMT so there is some clearance. It positions too far off the 1.0 hole at somewhere around X.110 and then rapids the back side of the boring bar into the part. Once I changed my drawers and re-watched the simulation screen you can see the move, ever so briefly. I can't figure out how to get the graphics slow down either.
I can't figure out where or how to set up the clearance in the conversational program. Type 1 general turning, then ID turning, I even set the piority to forward. The retract is set to .025. Maybe these bumps will iron out, but I am thinking that I would be better off to buy the turning module for EdgeCam since I am already using EdgeCam.
There have to be Mori programming gurus here. Any help would be much appreciated. Thanks
-Greg
I recently bought this 2002 CL2000BT and am on my second job on it. I successfully ran the first job with conversational programming. So I program the second, a threaded fitting and didn't see the crash coming.
The problem is that I drilled a 1 inch hole then went to my 3/4" solid carbide boring bar, CCMT so there is some clearance. It positions too far off the 1.0 hole at somewhere around X.110 and then rapids the back side of the boring bar into the part. Once I changed my drawers and re-watched the simulation screen you can see the move, ever so briefly. I can't figure out how to get the graphics slow down either.
I can't figure out where or how to set up the clearance in the conversational program. Type 1 general turning, then ID turning, I even set the piority to forward. The retract is set to .025. Maybe these bumps will iron out, but I am thinking that I would be better off to buy the turning module for EdgeCam since I am already using EdgeCam.
There have to be Mori programming gurus here. Any help would be much appreciated. Thanks
-Greg