I run a Okuma mill with a OSP 10M controller. It has a umbrella tool changer. All the programs are written with a G111 T whatever at the start of each tool.
The G111 is as follows.
OTCHK
IF [PT EQ VTLCN] NEND
T= PT M6
NEND RTS
My problem is if I change the G111 to a M6 I always get a wrong T command fault.
Is there a way to disable the G111? Not sure why I need it. Also on that mill if I call up a empty tool pocket it will not complete the tool change. Is there a parameter I can change to call up a empty toll pocket?
The G111 is as follows.
OTCHK
IF [PT EQ VTLCN] NEND
T= PT M6
NEND RTS
My problem is if I change the G111 to a M6 I always get a wrong T command fault.
Is there a way to disable the G111? Not sure why I need it. Also on that mill if I call up a empty tool pocket it will not complete the tool change. Is there a parameter I can change to call up a empty toll pocket?