Hey guys, I was going to order some milling chucks for my endmills and I came across a drawer here (new job) with a shitload of hydraulic chucks. I just want to know how they hold in comparison to milling chucks or endmill holders. I want to use them for HSM as shown in my videos but I don't want to risk them pulling out. Anyone know the holding force on them?
The brand is Erickson and the number on it is CV50BHCT100462
CV50BHCT100462 CV Hydraulic Chuck | Fastenal
Also are they ok to hold a weldon type shank? I wouldn't hold weldon endmills but rather insert drills that have a flat.
The brand is Erickson and the number on it is CV50BHCT100462
CV50BHCT100462 CV Hydraulic Chuck | Fastenal
Also are they ok to hold a weldon type shank? I wouldn't hold weldon endmills but rather insert drills that have a flat.